Home › The Garage › SPC
Lean

Statistical process control

Every process varies. The hard question is whether today’s number is just noise or a real signal. Control charts answer it — so you stop tampering with normal variation and act only on genuine change.

By LeanBean · Updated November 2026 · 6 min read
What's in this guide
  1. What SPC is
  2. How a control chart works
  3. Common vs special cause
  4. Using it well
  5. Common questions
Upper control limit Centre line (average) Lower control limit Signal
Points inside the limits are normal variation. The one point above is a real signal worth investigating.

What SPC is

Statistical process control is a way of telling signal from noise in a process over time. Every process varies — no two outputs are identical. SPC uses a control chart to show whether that variation is the ordinary background hum of a stable process, or a genuine change worth investigating. It stops the two most common mistakes: chasing random ups and downs, and missing a real shift buried in them.

How a control chart works

You plot a measurement over time against three lines: a centre line (the process average) and an upper and lower control limit, set from the process’s own variation — usually three standard deviations either side. The limits are not targets or specifications; they describe what this process does when nothing unusual is happening. As long as points fall randomly within the limits, the process is “in control” — stable and predictable.

Common vs special cause

Reacting to common cause as if it were special is tampering, and it usually makes things worse.

Using it well

Stabilise before you improve
A control chart first tells you whether a process is even predictable. If it is riddled with special causes, remove those first — you can’t improve a process you can’t predict. Once it is stable and in control, the chart becomes your early-warning system in the Control phase of DMAIC, catching drift long before it reaches the customer.

Describe a process. Get the whole analysis.

LeanBean turns a plain-language description of any process into a professional map — with Lean waste, SIPOC, design-thinking, AI-readiness and capacity analysis built in, and a Transformation Coach that sequences the fixes. Free to start.

Build your first map free →

The Garage — a community of practice

The Garage is where Lean, process and AI-readiness practitioners learn in the open — short lessons, real examples, and a place to compare notes. Join the community: follow along, try it on your own work, and share what you find.

Common questions

What is statistical process control?

A method that uses control charts to distinguish normal, inherent variation in a process from genuine signals of change. It helps teams act on real shifts while ignoring random noise, which prevents both over-reacting and missing real problems.

What is a control chart?

A time plot of a measurement against a centre line (the average) and upper and lower control limits derived from the process’s own variation. Points inside the limits that fall randomly indicate a stable process; points outside, or non-random patterns, are signals to investigate.

What is the difference between common-cause and special-cause variation?

Common-cause variation is the ordinary noise of a stable process and is improved by changing the process itself. Special-cause variation is an unusual signal — a specific event — that should be investigated individually. Treating common cause as special is called tampering and tends to make things worse.

Are control limits the same as specification limits?

No. Control limits describe what the process actually does based on its own variation; specification limits describe what the customer requires. A process can be in statistical control yet still fail to meet specification — the two answer different questions.

Related guides: DMAIC · Process cycle efficiency · Root cause analysis